Toyota Resistor Harness - Plug & Play Turn Signal Resistor Kit Prevents Hyperflash

Simple plug and play harness that prevents hyperflash when installing LED bulbs in your factory turn signals.  

Wire Harness: 2x Sparksmith Exclusive 7443 harnesses with integrated resistors

The Good Stuff: These aren't your cheap $15 Amazon adapters with those failure prone gold anodized resistors. No sir. This is a high quality setup that is hand made right here in the good ol' USA. Better still, we'll throw in some stainless screws to mount the resistors and dielectric grease so you can be sure your factory sockets will be in top shape for years to come. 

WHAT'S INCLUDED

Harness: 2x Toyota-type 3-pin Jumpers w/ integrated slim line resistors
Hardware: 4x #6x1/2" stainless steel, self drilling screws

The resistor kit comes with the Turn and Ground connected to each resistor which loads the circuit when the turn signal is used to prevent hyperflash.  The red Power output wire will be unused and remain available as an optional power source.

COMPATIBILITY

OEM: Fits most Nissan and Toyota 3-wire park/turn sockets. Just make sure the back of your socket matches the images shown.
TOYOTA: Sumitomo TS 090 Sealed Series connectors

TECH SPECS

Resistor: 7.5 ohm, 50W
Input: 3-wire flat male plug, Male, 3-pin: P/N 6188-0328
Output: 3-wire flat male plug, Female, 3-pin: P/N 6189-0177
Wiring: 14ga high temp, stranded copper